Charred Evergreen Oakvented gas logs

The collection in detail

A charred evergreen oak look, with the component references beside it.

Charred Evergreen Oak belongs to the G52 Radiant Fyre system. The manufacturer describes these logs as a fiber-enhanced refractory ceramic design, paired with the G52's radiant stainless-steel booster grid. That is a particular log-and-burner design, rather than a reason to put ENO logs onto any burner of the same width. The brochure's smallest nominal size reads 18/20 inches; the actual current log order model is ENO-18. Keep that distinction on a quote or replacement request. The larger log choices are 24 and 30 inches, while G52 burners use 18/20 and 24/30 groups. Controls range from natural-gas match-lit to factory pilot and remote assemblies. If you prefer propane or electronic operation, compare the complete selected burner model; the lowest match-lit reference does not describe every fuel/control combination.

• ENO is a G52-specific log family with a matched radiant booster-grid burner.
• Brochure 18/20 corresponds to the actual ENO-18 log SKU.
• Match-lit G52 is natural-gas-only; propane requires the documented valve-equipped model.

The priced selections shown here pair this family with G52 burner references where the manufacturer table documents compatibility. The available fuel choices are natural gas and propane. Controls listed in this family include match-lit natural gas, manual standing pilot, variable remote, electronic on/off remote, electronic variable remote.

The practical boundary

A beautiful flame still needs a suitable chimney.

A vented selection requires the fireplace and operating venting specified by the exact appliance. Heat leaves through that required venting. Choose this system for the open-fire experience, with the chimney condition and permanent venting provisions reviewed before installation.

The nominal 18/20 / 24 / 30-inch labels describe the offered set sizes. They do not establish the minimum firebox width, depth or opening height. Different control assemblies can change the space required.